INTRODUCTION

What is IoT Builder ?

IoT Builder is a product that works with Proteus Visual Designer for Arduino, Visual Designer for Raspberry Pi, and Visual Designer for MicroPython to develop remote user interfaces for embedded designs. It supports popular Raspberry Pi, Arduino and MicroPython hardware and lets you design the front panel, program behaviour, simulate, and then deploy to a network-connected device

See Also:

IoT Builder Compatible Hardware

 

The basic workflow is :

  • Create a Visual Designer (flowchart) project or a Proteus VSM source code project with an IOT enabled target such as Arduino Yun or Raspberry Pi 3.
  • Add the electronic shields, sensors and breakout boards to the schematic via the Visual Designer peripheral gallery.
  • Add IOT Controls (dials, buttons, displays, etc.) to the Virtual Front Panel and then lay out the user interface. All of these controls hook into the main program using simple Visual Designer flowchart methods making it quick and easy to program.
  • Write the program. All of the shields and controls discussed in the steps above present as simple flowchart methods (Visual Designer) or as drag and drop functions (Proteus VSM) making it simple and fun to develop.
  • Simulate and debug. Press play and interact with your front panel and your virtual hardware on the schematic. Set breakpoints and single step debug.
  • Deploy. Once everything is proven correct in Proteus use the programmer to deploy to the hardware. Then use your phone, tablet or browser to control your hardware appliance.

IoT Builder Targets

While other target platforms are in development IoT Builder is currently targeted at Arduino and Raspberry Pi.

See Also:

IoT Builder Compatible Hardware

Tutorial 1 : Blink an Led

The procedure above is slightly different if you are planning to create a source code project rather than a flowchart project as you will need to start with 'New Project' instead of 'New Flowchart Project'.

Source Code Projects

About this Documentation

This manual is intended to cover the use of the IOT Builder module in Proteus. IOT Builder is an add-on product to Visual Designer and so reference will be made throughout to Visual Designer programming methods. These should be easily understood in context but Visual Designer is discussed in full in the reference manual linked below:

Visual Designer

It is also entirely possible to use IoT Builder as an add-on to Proteus VSM for Arduino. This is discussed in the topic on source code projects and the use of the VSM Studio IDE is explored in more depth in that reference manual.

VSM Studio IDE